Shanghai and Shanghai stainless steel manufacturing co., LTD. Specialized in stainless steel casing of production and research and development, the stainless steel casing and the card card sets of pipe joint is suitable for use in medium material is in the form of oil, water, gas and other places no corrosive properties, stainless steel ferrule joint is a kind of sealed performance is good line the streets, tie-in use stainless steel card casing, connected to the line after use is very flexible, connected with solid and reliable, and the advantages of good sealing characteristics.

Key points for installation of pipe joints in the form of clamping sleeve and clamping sleeve:

1. Pipes that need to be cleaned with an acidic solution should be cleaned with an acidic solution first.

2. According to the practical use of the required length, use of sawing machine or professional pipe cutting machine and other equipment for cutting the pipe, not allowed to use solvent or abrasive cut-off, clean the inside and outside circular tube above the burr and metal debris and stains, remove card set of forms of pipe joint anti-rust additives and besmirch, at the same time guarantee card stainless steel casing the roundness of the road.

3. Put the nuts and clamps inside the pipe one after the other. The cutting edge of the front end of the clamps should be at least 3mm away from the junction of the pipe.

4. Tighten the retaining nut slowly while rotating the rotor until the tube is not moving, about 2/3 to 4/3 turns of the retaining nut.

5. Disassemble to check whether the card sleeve has been inserted into the pipe and the position is accurate.The sleeve does not allow the direction of the axis to shift, can be slightly rotating.

6. Turn the screw nut again after checking it meets the requirements.